I usually run my subs through the low pass line level ins/outs. Last night I tried using the two sub out outputs and when ever I turn the 1066 on or off the subs POP so loud I thought the entire house was going to explode. My HT in the basement and my wife two floors up thought I blew something in the electrical box it was that loud. I turned the volume on the subs down to about 30% and the pop is still there, but not nearly as bad. I'm running version 1.48 of the firmware and they pop no matter what the power on settings are(standby, always on direct). Anyone else have this problem?
Thanks
"What do you mean it's too loud? My ears aren't even bleeding yet!"
Radden Home Theater
Thanks
"What do you mean it's too loud? My ears aren't even bleeding yet!"
Radden Home Theater
Comment