Hi,
My set up is a NAD PRE, RB 1080 power and B&W 603 s. The 1080 has 2 sets of speaker terminals though the manual does not indicate so!!!! Any way my question is whether it is better to use all the provided terminals in a biwire set up?
At the moment they are clubbed into 1 positve and 1 negative at the amp end as my earlier amp had only 1 set of terminals.
This may be a dumb question for you guys but would using both sets of terminals amount to halving the power/impedence?
Here in India the rotel dealer just cannot guide you in any way?
Awaiting a reply. Thanks.
My set up is a NAD PRE, RB 1080 power and B&W 603 s. The 1080 has 2 sets of speaker terminals though the manual does not indicate so!!!! Any way my question is whether it is better to use all the provided terminals in a biwire set up?
At the moment they are clubbed into 1 positve and 1 negative at the amp end as my earlier amp had only 1 set of terminals.
This may be a dumb question for you guys but would using both sets of terminals amount to halving the power/impedence?
Here in India the rotel dealer just cannot guide you in any way?
Awaiting a reply. Thanks.
Comment