What are the numbers of the resistors to be cut? Andrew's diagram is gone.
-
-
This thread has the diagram. I'll look into why the other images aren't showing up but the diagram that is showing is really the one you need.
:later: gents -
That's for the 1055 though.Comment
-
I think its the same board.Comment
-
Well I need to be 100% sure as you can understand.Comment
-
In that case I suggest sending it in to Rotel to have them do the fix. Its not that expensive and turn around should be reasonably quick.Comment
-
Here's the 1066 link
It's in the Rotel Links "Sticky"
Good luck, I did mine a while back. It was unnerving opening it up but once I got in there I was relieved to find it quite straight forward and a cinch :TJasonComment
-
I have found that link but the diagram is missing. I just need to know which resistors.Comment
-
Anyone know?Comment
-
The resistor numbers are the same reguardless of where they are positioned. I've lost the pages I had detailing the 1066, but it's still RW167 & RW170.
Kevin D.Comment
-
Originally posted by Kevin D
Perfect that is what I needed to know and if someone could give me a clue on what board they're located?Comment
-
They are actually right on the multi-input board. Just take the cover off and find the board all the multi-room RCA's attach too. Pretty hard to miss.
Kevin D.Comment
-
Just bought a 1066/1075 (not even hooked up yet) and came across the "double bass" issue with the multi-inputs here.
Sent Rotel tech-support an e-mail about the resistor cut fix and rec'd e-mail indicating that the "double bass concern is erroneous" and that there... -
The ones on this site from 4 years ago are not linking anymore and I'm in need of a diagram showing where the 2 resistors were that solved the double bass issue on the multichannel inputs. Anyone have this? THANKS! -
1066 BM setup
Hi! New to the forum, as I just got my 1066/1075 combo last week.
I'm glad I found this site, because I'm having a hard time trying to figure out how to do my bass management.
My equipment is as follows:
RSP 1066 / 1075
Outlaw... -
I know this subject has been beaten to death but here it is again.
I'm planning on getting a demo 1066 tomorrow, I know that the 1066 has been replace by the 1068, but Dolby Prologic IIx doesn't do anything for me since I'm running 5.1. I will be doing the bass management fix for the 1066 and... -
Here's a diagram of the two resistors that you need to "cut" to remove the bass redirect on the multichannel inputs. This fix only works for the 1066 NOT the 1055 model. I post this information for your benefit but legally neither I, Rotel or HTGuide in any way shape or form will be held accountable...
Comment