I want to connect a dvd player, Xbox, and cable box to my Pioneer tv using component video . The tv has two component ins. I hooked the cable box directly to component input 1 on the tv, and and the component out of the 1066 to the tv's component input 2. Then I connected the Xbox and dvd player to the 1066 component in's. My hope was to use the 1066 to switch the video between the Xbox and dvd but I was unable to get a video signal from either source. I unhooked the dvd and ran it directly to the component input 2 on the tv and got a picture, but when I reconnected to the 1066 and tried again, still no luck. What did I do wrong Thanks
-
-
I assume that you setup the 1066 with the correct imputs and that you select that input correctly?
Trevor -
Yes, I selected video input 2 on the Tv. I was able to able to get audio, but no video. ThanksComment
-
I don't have a 1066...but is there a way to assign different video inputs or a way to activate the component inputs? i.e. turn them on/off?
Recheck your connections, make sure your in is in and outs are outs...Comment
-
This is really hard not being able to see anything but can you check your input setup and ensure the correct video input is assigned to the correct input selector on your remote.
TrevorComment
-
I connected the Xbox to the component imput 1 and the dvd player to the component in 2. I connected the component out to the video 2 in on the TV. I tried to select the video 1 and 2 on the Rotel using both the remote and the push buttons on the front of the unit, no luck. I changed to the correct input on the tv and verified by running the dvd direct and getting video, I can't find anything in the manual about inabling the component video. I'm about to give up and just use s-video for the Xbox. I appreciate all help.Comment
-
Hi guys,
I just replaced my Denon 3802 with a Rotel 1066 yesterday, hooked up to a Rotel 1075 amp. I haven't had much of a chance to listen to it yet but so far it sounds awesome.
I have a problem with my video connections though. I had no problems with the Denon 3802 so... -
Dear Rotel enthousiasts,
Yesterday I bought a Pioneer plasma screen to complete my Rotel setup
After concluding all the (required) connections I found out that there's a problem displaying (progressive or not) an 1060 image on the Plasma screen.
I really hope... -
I have the Rotel 1066 processor and have a question regarding hooking it up.
According to the manual, the Component Inputs on the processor cannot be assigned, so I have connected Component 1 input to my DVD player and the Component 2 input to my HDTV cable box.
The manual... -
Hello,
Thanks to reading your forum for the past few days, I pulled the trigger and purchased my 1066 yesterday. Whee!
I have a boat-load of questions, but here is my first:
Do you recommend that I use the 1066 for video switching?
I have:
...16 February 2003, 15:29 Sunday -
I recently moved my cable box from my HT system to another tv as I rarely watched cable on the HT.As I was looking at the setup menus on my RSX 1057 to remove the cable box from the inputs and reassign the dvd and dvd audio I messed up the settings on Input setup.The video 1 input is supposed to be...
Comment