I keep wondering about a board defect causing this problem. I mean I have found shorts to ground around pads, and whose knows what stray capacitances or resistances there are on the board that aren't quite a short?
I'll measure the resistances again and see if they check out. the crossover frequency is on the dot, but maybe a resistance path that shouldn't be there is causing problems? Just just on part of the positive half cycle?
This is so weard!
I'll measure the resistances again and see if they check out. the crossover frequency is on the dot, but maybe a resistance path that shouldn't be there is causing problems? Just just on part of the positive half cycle?
This is so weard!
Comment