Hi everyone,
I have two questions about newly purchased 1068 and 1075 for my HT system.
1. When I turn off the 1075 amp, the red LED turns off. Then, all 5 protection fault lights come on at the same time for a second, then shut down in unison. Is this normal? I could not find any mention of it in the manual.
2. When my roommate went to turn on my 1068 this morning, he noticed the standby light was not on. He needed to turn the switch in the back of the 1068 off and then back on for the standby light to come back on. The 1068 is plugged into a surge supressor, and the power did not go off last night. Has this happened to anyone? What might be wrong?
I have two questions about newly purchased 1068 and 1075 for my HT system.
1. When I turn off the 1075 amp, the red LED turns off. Then, all 5 protection fault lights come on at the same time for a second, then shut down in unison. Is this normal? I could not find any mention of it in the manual.
2. When my roommate went to turn on my 1068 this morning, he noticed the standby light was not on. He needed to turn the switch in the back of the 1068 off and then back on for the standby light to come back on. The 1068 is plugged into a surge supressor, and the power did not go off last night. Has this happened to anyone? What might be wrong?
Comment