1098 owner Good news Bad news

[solihullfatboy]

Good news I got my 1098 at the weekend and have set it all up and for the first few hours it was great !

Bad news , after a few hours use it seems to have developed a fault in that the centre channel/speaker keeps switching from really quite ie no voices to its proper setting ie voices, haveing explored further even with test tone this appears to be happening so it none of the sources.

I've checked all the connections so its not that, I've tried both centre outputs and the results are same. When the unit was shipped it was 2.1.1 firmware so i upgraded to 2.1.2 and everything appeared to go ok with check sums being the same.

So is it a fault with the processor ? any ideas ?

thanks

[kneptune]

Have you tried resetting the 1098 back to factory defaults and re-evalauting again?

-Kevin

[Locutus2k]

Before accusing the 1098 i will try the following: connect the center out of the 1098 at the front (r or l) IN of the amplifier and try again. It may be a faulty channel on the amplifier.