At the moment I have my Toshiba HD A1 connected via the analog inputs on the 1068 for Dolby Digital Plus and True HD. Does anyone know if the Sub 2 can work in addition to the Sub 1 when running in bypass mode with a 1068?
-
-
Dunno but a Y-connector would.
KalKal Rubinson
_______________________________
"Music in the Round"
Senior Contributing Editor, Stereophile
http://forum.stereophile.com/category/music-round -
The following is from the manual:
"Both SUB outputs provide the same signal. Use either connnection for a single subwoofer. Use both connections to hook up two subwoofers."BradComment
-
Back of 1068 ,I believe, should as I have for the In my 1098 for HT have 2 sub Inputs ,so that should work In bypass mode too just like your 1 st Sub.
If you don't have 2 Inputs ,then you can daisy the conecction, and Sub 1 will be the Main command.
Hope that helps!!!
I have 2 subs ASW 850, and connected in 2 different Sub Inputs In 1098, and In Bypass mode It is Sensational!!!
Good Luck and keep us posted!
CheersComment
-
I keep losing the sub output when i have RCA coming in from my ipod or other source. Everything else plays fine, i just lose the subwoofer.
The only way around it is to go into the 1057's menu and reset to factory. Anyone have a clue why this is happening? All the other sources are fine,... -
Easy folks,
just upgraded from RA-1062 to a HT setup with a RSX-1056. I haven't quite tweaked it to perfection yet. I'm running Monitor Audio GR10's and Rel Q201E sub. Haven't hooked up the rest of the speakers yet, but got some B&W's 601's for rears.
Anyway, 2 channel... -
Good day all…
Currently I have a velodyne SPL10 sub hooked to the sub out on my 1068 which is only used for movies. I would like to also be able to use the sub in 2ch bypass. After my SACD/DVD STB I hooked my cd player up the multi channel inputs and turned the LF redirect on and was... -
I'm having a tough time finding a quality crossover to filter the full range line-level signal from my receiver's pre-outs prior to running them through a separate 2-channel amp (NAD C370) to power the 2nd set of subwoofer voice coils on my Gallo Reference 3's. Guess I'll just have to wait for the Gallo...06 July 2005, 01:29 Wednesday -
I have spoken with Behringer and they have shown serious interest in designing a replacement for the BFD that is more suited to the consumer market. As many of you may already know... the DSP1124 has been discontinued. The replacement FBQ2496 only offers 1 preset and still doesn't get us many of the...
Comment