Hi, I am just a pround owner of RSP1068 and RMB1075. I have a few questions and hope that someone out there could answer:
1. When I power up the 1068, there is a little pop sound when the RMB1075 was powered up by the 12v trigger. Is this pop sound normal?
2. In the speaker advance setup manual, even though I configure it as "large" for my front speaker. It still ask for a cross over frequency setting in the advance speaker setup manual. Is it normal?
3. My 1068 software version is 1.1.3 and the latest in the Rotel web site is 1.1.7. Should I upgrade it even if everything is OK? Is there anything I should be pay attention to during the software upgrade process.
4. Should I set the subwoofer setting to "yes" or "max". I have a REL subwoofer and it is connecting via the LFE connection plus a high level input from the front left and right speaker.
Thanks!!
1. When I power up the 1068, there is a little pop sound when the RMB1075 was powered up by the 12v trigger. Is this pop sound normal?
2. In the speaker advance setup manual, even though I configure it as "large" for my front speaker. It still ask for a cross over frequency setting in the advance speaker setup manual. Is it normal?
3. My 1068 software version is 1.1.3 and the latest in the Rotel web site is 1.1.7. Should I upgrade it even if everything is OK? Is there anything I should be pay attention to during the software upgrade process.
4. Should I set the subwoofer setting to "yes" or "max". I have a REL subwoofer and it is connecting via the LFE connection plus a high level input from the front left and right speaker.
Thanks!!
Comment