Dear All,
I have a 6month old PLV-Z2 projecting about 2m to a 6ft screen.
Recently I have begun to see a red halo, about 1-2 pixels wide above OSD menus and also from a component signal from a DVD. This is accompanied by
a similar blue effect below.
Not sure what the technical term for this is, perhaps RGB convergence?
I believe this is probably due to the alignment of the 3 LCD panels within the unit. My questions is:
1. can this be corrected thru one of the 500 options in the service menu
2. does it mean a back to base for a service engineer fix.
Any help greatly appreciated.
Cheers
Adrian
I have a 6month old PLV-Z2 projecting about 2m to a 6ft screen.
Recently I have begun to see a red halo, about 1-2 pixels wide above OSD menus and also from a component signal from a DVD. This is accompanied by
a similar blue effect below.
Not sure what the technical term for this is, perhaps RGB convergence?
I believe this is probably due to the alignment of the 3 LCD panels within the unit. My questions is:
1. can this be corrected thru one of the 500 options in the service menu
2. does it mean a back to base for a service engineer fix.
Any help greatly appreciated.
Cheers
Adrian
Comment