RSX-1055 12v trigger
At the risk of redundancy, does the 12v trigger in an RSX-1055 get controlled by firmware? The manual is vauge, and I believe I have coverd most of the bases listed in other posts, settings, ect... My RMB-1075 waits for the 12 volts when the toggle switch is set to such, I took my meter and am getting no 12 volt output from the 1055. Are these fused sperately from other circuitry? I havent popped the cover off yet and am hesitant to do so because of disconect time spent to probaly discover a software switch is not set. Rotel has yet to respond to my email asking the same thing, so anyone here experienced similar problem, if so how did you resolve? Thanx
-
I was reading the FAQ on Rotels website and it states that you need a 1/8" Mono cable to send the 12v to trigger a amp turn on, but after testing with a multi meter, I had NO voltage being sent and my amp would not turn on. I then proceeded to grab a 1/8" stereo cable and tested it with a... -
Hi!
Does anyone know how many mA the 12V trigger out jacks can deliver, and if the it can be used to power a small fan?
I have my system in a cabinet, and to ensure proper cooling, I thought I'd mount a small computer fan in the cabinet wall. So I thought it would be really... -
Hello guys,
I've been searching this kind of question regarding on 12v trigger it seems that most of the topics is about RB-1080 and getting some problem like bad fuses, L&R ch not working due to resistor, caps and etc. Just wondering if there's anyone here encounter same problem... -
Hi,
I have recently picked up a Rotel 1570/1575, and I am having a few problems with the 12v trigger between the 1570/1575. I am unable to get the 1575 to power on while using the trigger when turning the 1570 on. I have the trigger cable connected to trigger out 1 on the 1570, and the... -
Hi all,
I recently had a new home threatre installed which consists of my current Onkyo 787 receiver acting as a processor and new Rotel RMB-1075 and RB-1070 providing the amplification for a 7.1 setup (which sounds fantasic btw). The problem being that my Onkyo doesn't have a 12 volt trigger...