Hey All,
New to the forum and glad to find what looks like a very knowledgable community to bounce questions off of.
I have a brand new out of the box 1066 that had rev. 1.1.5-something and found that there was rev. 1.1.7. So I followed all of the instructions on Rotel's website to do the upgrade and everything up to the completion of the software checksum was great. I got the same hex code for the checksum and figured it was all good.
So I disconnected the cable, powered down the 1066, flipped the software dipswitches back to OFF and then tried to power back on. I got the front panel to completely light up and then NOTHING! ARGH!
So now the only way I get any response out of the unit is to unplug and switch off the 1066 for a few minutes (4 - 6) and then plug back in and switch on. No blue standby light, no indication of power at all except the 2 second display check.
WHAT DID I DO? Is this my fault? Anybody have the same or similar issue?
Thank you in advance for your help...
Charles Soper
New to the forum and glad to find what looks like a very knowledgable community to bounce questions off of.
I have a brand new out of the box 1066 that had rev. 1.1.5-something and found that there was rev. 1.1.7. So I followed all of the instructions on Rotel's website to do the upgrade and everything up to the completion of the software checksum was great. I got the same hex code for the checksum and figured it was all good.
So I disconnected the cable, powered down the 1066, flipped the software dipswitches back to OFF and then tried to power back on. I got the front panel to completely light up and then NOTHING! ARGH!
So now the only way I get any response out of the unit is to unplug and switch off the 1066 for a few minutes (4 - 6) and then plug back in and switch on. No blue standby light, no indication of power at all except the 2 second display check.
WHAT DID I DO? Is this my fault? Anybody have the same or similar issue?
Thank you in advance for your help...
Charles Soper
Comment