what should, or do you think should sound better a 1080 2 channel amp or a 1075 true biamped for main speakers????
-
-
IMO I'd place my bets on the 1080 sounding better but there's a lot of variables at play here such as quality of interconnects and splitters, the cross over used in the speakers, the type and size of drivers in the speaker, the lenght of the speaker cable, are the speakers set to large or small? etc. -
Yeah to many variables to say for certain... Sounds like a demo is needed! :B
JasonJasonComment
-
I would have to place my bet alongside Andrew´s! - The 1075 is not the greatest amp ever built for stereo...but then again..it was never ment to be....it´s a great HT amp.
If you want a good stereo amp.....consider a classA or perhaps even the new "digital" amp´s....like the new "Predator" from LCAudio:
It is getting some rather good reviews, even compared with more expensive class A reference gear.Comment
-
stayed with true biamp
well i bought another 1075 i'm gonna stay biamped. now i need some good interconnects (biamped) any ideas?????????????Comment
-
Michael click the CatCables banner on this site and email doug the owner for a quote and suggestion on which to get. There's a new review by a member that just bought some of his cables in the Chalet area too. I have several of his cables and they're amazing and well priced.Comment
-
Last week i got another RB-1080 (stock is almost gone so i wanted to have another one which i'll use maybe for rears, maybe for center, maybe for next room, maybe to try biamping, so i thinked that definitly is not a waste).
I tried to biamp my speakers using Van Den Hull Cables CS-122.... -
I'm having thoughts about upgrading my system and want some advice on which direction to proceed. Currently I have a RMB1075 driving the fronts center and side surrounds of a 7.1 system with a RB1050 driving the rears. I have contemplated two different possibilities. The first is to change the 1050... -
I need people's advice and opinions on my setup. I have the following equipment:
1095 amp 200 x 5
1080 amp (new, still in box) 200 x 2
B&W Nautilus 803 fronts
B&W HCM CNT center (esentially part of the newer 700 series)
Polk Audio 755 Inwalls... -
Hello. I'm new here, but i'm reading the posts here a long time. Now i registered, because i have an important question or is it only important for me?
Now i have a RMB1075 as amplifier. My Denon 1800 has only preouts for fronts and center and i biamp my KEFs. For the future with another processor,... -
Hi Guys ,
I need some advice as to what is best .
I want to add another amp to my RSX1065 to run some B&W604S3's
Do I :
1.get RB 1080 and biwire the 604's(200w per speaker)
2.get RMB1075 and biamp the 604's (2x120w per speaker and leaves one channel spare...
Comment