RC-1082 - Two inputs selected at same time??

[annakova]

I'm enjoying my new RC-1082 immensely and am glad I am not still waiting on the 15 series.

An odd thing has happened several times though. I turn on my system with a Harmony One remote, and usually it works just fine. But occasionally (three or four times now) it starts with two pre-amp inputs selected, i.e. two of the blue lights over the input buttons glowing and both of those two inputs sending music to the speakers.

I am surprised that this is even possible, thinking that there would be some hardware or software mechanism to allow only one input to be active at a time. Has this happened to anyone else? Is it something that can or should be fixed, maybe with a software upgrade or reboot or something? When this double input occurs (it is typically the tuner and Aux1), I can select either one by pressing the corresponding remote button and the other input turns off and deselects itself and everything seems normal. Can anyone explain this?

Anna

[hifiguymi]

That is strange. You can try a simple reboot by unplugging it for about 30 seconds or so and then plugging it back in. If that doesn't cure the problem then contact your dealer or tech support at techsupport@bwgroupusa.com .

Eric

[miner]

One strange phenom that happened with my RC-1082. In standby mode, power off, if I touch an input (like phono) button, it will power on the pre just as if I pushed the power button.

Strange?

[Kevin D]

That's normal and works on the surround models as well. Should work from the remote as well.

Kevin D.

[bigburner]

One strange phenom that happened with my RC-1082. In standby mode, power off, if I touch an input (like phono) button, it will power on the pre just as if I pushed the power button.

Strange?

miner, I can confirm that my RC-1082 does this too.

Nigel.

[miner]

Kevin D. & Nigel, thanks for verifying the input power-on cycle.