Hi guy's
I allways had my sub crossover on the Rotel RSX 1057 on 100hz. I have a large room and like little bit more bass. Recently i got a new Paradigm Servo 15 V2 to replace my old mission Sub. Anyways now i developed a Poping sound when the receiver changes settings from prologic to dolby digital.
Never had a poping sound before, and was wondering if this is normal? I am also using a Y-Adapter on the sub that i never used on the mission sub. I wonder if this have any contribution to the poping noise?
I turned down the crossover to 80Hz but still didn't make a difference. I really can't tell the difference between 80 an 100 in my room anyways..
So is this normal or should i have the receiver looked at?
Note: All my speakers are hooked up to the rotel RMB 1075. I am using the 1057 as a pre/pro...
I allways had my sub crossover on the Rotel RSX 1057 on 100hz. I have a large room and like little bit more bass. Recently i got a new Paradigm Servo 15 V2 to replace my old mission Sub. Anyways now i developed a Poping sound when the receiver changes settings from prologic to dolby digital.
Never had a poping sound before, and was wondering if this is normal? I am also using a Y-Adapter on the sub that i never used on the mission sub. I wonder if this have any contribution to the poping noise?
I turned down the crossover to 80Hz but still didn't make a difference. I really can't tell the difference between 80 an 100 in my room anyways..
So is this normal or should i have the receiver looked at?
Note: All my speakers are hooked up to the rotel RMB 1075. I am using the 1057 as a pre/pro...
Comment