I am thinking about connecting a pair of 8 om speakers in parallel to work as my center. Anybody see a problem with the 1075 running these? Thanks.
-
-
The amp will handle it fine. Having two point sources for the center chanel may not sound as good as one speaker however. Unless you are in the sweet spot for the two center channels it won't be as detailed.
Eric -
good point! thanks.Comment
-
jus wondering since we are on the topic of 1075, does anyone have experiences of these multi channel poweramps from a point where, if we use only 2/5 channels, does the efficiency or power output increase versus when u use 5/5 channels?
e reason is i am planning to use only 3 out of the 5 channels and would like to know any benefits are there
Comment
-
Since the power supply is only running three out of the five channels it will produce more power than if all five were being used. I don't know how much more because incoming line voltage and speaker load all play a part in that, but it is more.Originally posted by deepakvalijus wondering since we are on the topic of 1075, does anyone have experiences of these multi channel poweramps from a point where, if we use only 2/5 channels, does the efficiency or power output increase versus when u use 5/5 channels?
e reason is i am planning to use only 3 out of the 5 channels and would like to know any benefits are there
EricComment
-
I run four full range speakers up front, everything in stereo, powered by the RMB-1075 and two more in the rear powered with my yammie rec... and it sounds fantastic. (Each getting their own channel ie. not parallel)
I am also powering my Velodyne HGS-10 voicecoil's with the center channel from my 1075 until I can send the amp section in for repair. Its 6ohms and rated to 1300watts rms so it takes all it can get.
You should trying playing F.E.A.R. on this rig for the first time, I tell ya, if this doesn't give you a heart attack then your in good shape :W
I would say I am in the sweet spot though :rofl:
Thinking about investing into an RLC-1040 next.Comment
-
Hello everyone,
I am planning to upgrade my current system (5.1, see signature below for full details) to a 7.1 system with a pair of MonitorAudio GS60.
I have to admit that this new system will be the heart of a brand new HC + Stereo system in my new house (in construction... -
I would like to get some thoughts on the change over of my system. I purchased a RB 1070 about a month ago, and I am looking to switch over to separates in the next couple months. My current system is:
Denon 3802 (will be upgarded)
RB 1070 powering the fronts
Toshiba SD... -
I have the following HT setup :
RSX-1056
RB-1070 for front channels
RMB-1075 for center, surround and back channels
B&W DM603 S3 Front
B&W LCR600 center
B&W DM602 S3 surround
B&W LCR600 center back
B&W ASW-600 sub
... -
Hi,
I was wondering whether someone has experienced anything like this. Just a few weeks ago, after watching a movie. I turned off my amplifier RMB 1075 and heard a loud pop. I cannot really tell if it came from the amp or speaker, but one thing I noticed though was that the protection light... -
First off, what a great forum...being my first post, I would like to express my appreciation of such a well organized and informative forum. Keep it up!
To All Rotelian's: I have seen the light, after a few years of interest in Home Theater I have decided to quit playing around and...
Comment