1067 setup help needed

[nmit5903]

After some 20 hrs of trying to setup my new 1067 and numerous telephone calls to the dealer, I am not progressing. I am hooking up a 1050 and set-top box via Component 1 and 3 inputs and coax sound inputs 1 and 3. The AMP is connected up to a Sony Plasma TV (via the component output) and BW 600 series 3 speakers.

I cannot get sound and have been unable to get the OSD function to work in order to setup the sound inputs and outputs.

Any help much appreciated.

[Robo1067]

I had the same sort of problem with my 1067 where I could not access the OSD. I was informed by the helpful people in this club that I had to press the AUD button 1st (top left directly below LCD screen on remote) then 'menu' and then 'enter' I think the order is and bingo. You can then sort out the inputs and outputs from there. Once you get the OSD it is very easy.
I am not 100% sure but OSD may not be output via component so you may have to run a s-video cable just for this.
Hope this helps as it did for me
And I am VERY happy with my unit, no hisses, pops, gurgles just great sound :T .
Rob

[Kevin D]

OSD is available through component on the 1067. If your DVD player is set to progressive and your set-top box is HD, you probably won't be able to see the OSD if they are on. Try switching to video 2 or 4 before trying the OSD.

Like Rob said, it's crutial that you select the AUD mode on the remote before attempting any Rotel function aside from volume.

Kevin D.

[nmit5903]

Many thanks Keven and Robo - it works. Hopefully plain sailing from here. Wish I ha looked for this site sooner.

[Cornchips]

Menu is visable with Progressive Scan

If you've been able to access the menu (at all) -- here's the fix:

From the initial menu, scroll down the left to either "Options or Misc".

Towards the bottom of the list you'll see something about OSD or Progressive Scan -- like 2 from the bottom.

You can choose V2 or V3 or both and the RSX-1067 will "switch" from the present video source to another internal source (the menu system) whenever you press the menu button on the remote.

BTW: This an "actual" signal switch for the RSX-1067 -- expect a slight delay and minor screen flicker when accessing the menu AND when switching back to your other sources.

Hope this helps...