12v trigger - problem

[radim]

Hello, I've 1098 and by 12v trigger cable i control power amp 1095, cd and dvd players. Sometimes during hearing are my controlling components spontaneous switched off.
Why?
Is this interaction 12v cable with power or antenna (tv and satellit) cables?

thanks, radim

[Marlboroman]

I would contact your dealer and see about sending your 1098 in to have it checked out by a technician. That does not sound like normal operation to me.

[Azeke]

Radim,

You will probably need to check you 12v trigger assignments (in the menu). You can set them to 1,2,3 or all, depending on your input source.

Best regards,

Azeke

[radim]

Not long ago I moved to the new house. At the old house was 12v trigger without any problem. Now I have problem described in my thread.
So I think that 1098 is o.k. and issue is in power or tv(sat) cables.

What do you think about it ?

[grit]

I'd try replacing the 12v cables first. You may have developed a short, and it's a quick/easy fix/test.

[Kevin D]

Are your trigger cables daisy chained? (IE, 1098-amp-dvd-cd) or single runs? (1098-amp,1098-cd,1098-dvd)

If it's dasiy chained, swap the first cable with the last. If just the last device turns off randomly, it's the cable. If they all still turn off it's something else.

Kevin D.

[radim]

Thank you for your replies but I must say, meanwhile the problem isn't frozen out.

radim

[Marcel54]

I still have the same problem. In the past there was a very long thread about this problem, so search the Rotel forum and you get some more info on this.

[Azeke]

I believe that the lastest firmware fixed this problem, I could be wrong however. Just for giggles and kicks check to ensure you have the lastest firmware installed.

Peace and blessings,

Azeke

[radim]

I loaded the latest firmware for 1098.
Meanwhile the 12v trigger is o.k.
Maybe this problem will be frozen out.

radim

[radim]

Oh, no. Again my cd and power amp are off.
Interesting is, when I turn off (only stand by mode) my 1098 and then turn on again, cd and amp are still off. I have to turn off 1098 by the switch on the back side of processor and then is all o.k..

radim