Recently replaced my Yamaha 5.1 receiver with a 1075/1066 set up. My question is whether or not I can use my multi room speaker selector that use to run off my Yamaha A/B selector(B setting) off of the 1075 amp. The components sound awesome in my HT setup, but I had three sets of small speakers in other rooms running off the room speaker selector with the receiver. I appreciate any suggestions. Thanks
-
1066 BM setup
Hi! New to the forum, as I just got my 1066/1075 combo last week.
I'm glad I found this site, because I'm having a hard time trying to figure out how to do my bass management.
My equipment is as follows:
RSP 1066 / 1075
Outlaw... -
I auditioned a 1066/1095 setup yesterday and really liked it. The total cost is a bit above my budget. I could reasonably afford a 1066/1075 combination though.
How much of a difference would I notice between the 1075 (120 W) and 1095 (200 W) amplifiers? I listen to 2-channel music (analog... -
Hello, I am new to this thread and will definately be a Rotelian pretty soon, just need help on deciding which will be better for me, a Rotel rsx-1056 or a Rotel 1075 with a Yamaha RXV-1400 as the pre/pro.
Couple things about my situation :
1. Cost will be about the same... -
I would like to get some thoughts on the change over of my system. I purchased a RB 1070 about a month ago, and I am looking to switch over to separates in the next couple months. My current system is:
Denon 3802 (will be upgarded)
RB 1070 powering the fronts
Toshiba SD... -
As per Dre J's bass management reports and solutions, the best way to connect the 1066 and an ICBM (not including 5.1 inputs) is to set the sub to "off" in the 1066 menu setup, sending LFE bass to the front channels, and then letting the ICBM sort it out. The downside to this setup is the...