Recently replaced my Yamaha 5.1 receiver with a 1075/1066 set up. My question is whether or not I can use my multi room speaker selector that use to run off my Yamaha A/B selector(B setting) off of the 1075 amp. The components sound awesome in my HT setup, but I had three sets of small speakers in other rooms running off the room speaker selector with the receiver. I appreciate any suggestions. Thanks
-
1066 BM setup
Hi! New to the forum, as I just got my 1066/1075 combo last week.
I'm glad I found this site, because I'm having a hard time trying to figure out how to do my bass management.
My equipment is as follows:
RSP 1066 / 1075
Outlaw... -
I auditioned a 1066/1095 setup yesterday and really liked it. The total cost is a bit above my budget. I could reasonably afford a 1066/1075 combination though.
How much of a difference would I notice between the 1075 (120 W) and 1095 (200 W) amplifiers? I listen to 2-channel music (analog... -
Hello, I am new to this thread and will definately be a Rotelian pretty soon, just need help on deciding which will be better for me, a Rotel rsx-1056 or a Rotel 1075 with a Yamaha RXV-1400 as the pre/pro.
Couple things about my situation :
1. Cost will be about the same... -
I would like to get some thoughts on the change over of my system. I purchased a RB 1070 about a month ago, and I am looking to switch over to separates in the next couple months. My current system is:
Denon 3802 (will be upgarded)
RB 1070 powering the fronts
Toshiba SD... -
hi everyone ive been lurking for some time ang this is my 1st time to post.
i am thinking of adding a power amp to my 5.1 system. i am currently using:
avr - onkyo tx-sr702 100x7
lf/rf- 604s2
c- lcr6s2
ls/rs- 601s3
sw- m&k mx-105mk2
...