Alright guys, techy question here.
I have a C2 controller driving my system. I have an A52 to drive my main 5 channels, and a bridged A23 for my sub. I have two custom made bookshelf speakers (as mains, driven by the A52) that sit on top of two custom made woofers. These woofers are hooked up to the Programmable Aux Channels and driven through an A23 amp and are crossed over at 250 Hz utilising the on board filtering. I also have a separate Sub driven by a mono-bridged A23, that is crossed over at 70 Hz.
My question is this. What would be the correct delay setting for the Aux Channels to sink the woofers correctly with the mains?
Thanks in advance.
I have a C2 controller driving my system. I have an A52 to drive my main 5 channels, and a bridged A23 for my sub. I have two custom made bookshelf speakers (as mains, driven by the A52) that sit on top of two custom made woofers. These woofers are hooked up to the Programmable Aux Channels and driven through an A23 amp and are crossed over at 250 Hz utilising the on board filtering. I also have a separate Sub driven by a mono-bridged A23, that is crossed over at 70 Hz.
My question is this. What would be the correct delay setting for the Aux Channels to sink the woofers correctly with the mains?
Thanks in advance.
Comment