Onkyo 805 8 ohm?

[Jb&w]

I setup my system with The mic, and It put my speakers on 6 ohms. I can only put it on 6 or 4 ohms. Does any one know how I can change it to 8 ohms?

[ClosetSciFiGeek]

Does not Matter unless Unit goes into protect mode

All the 4ohm setting does is limit the current output if you have a low impedance speaker hooked up. I would leave it on 6ohm setting unless it goes into protection mode. If it does go into protection mode then turn the unit off and select the 4ohm setting. Limiting the current output is not good for the sound, only good to save the equipment if your low impedance speaker tries to draw too much current.

[Jb&w]

Ok thank you for the reply