I need a 2 ohm capable sub amp with at least a 1000 watts. Does anyone know of any?
-
-
The buttkicker amp works well:
• 1000 Watts @ 4 ohms
• 1900 Watts @ 2 ohms
• Can power 1, 2, 3, or 4 ButtKicker LFE transducers
• Class D switching technology
• Variable high cutoff, 40 - 160 Hz
• Low cutoff, 25 Hz switchable
• RCA and 1/4” inputs with 160m Volt and 1.25 Volt sensitivities
• Either 120v or 240v versions. NOT SWITCHABLE
I'm runing two 4ohm SVS subs on my Rotel RB-1091. Depending on how hard you have to push it, might work fine for you as well. A lot better sound then the BK one.
Kevin D. -
Unfortunately independent testing shows the BK amp doesn't produce the rated power and it has very high distortion. So it's probably good advise to follow the Guitammer company when they say it's not recommended for subwoofer duty.
There are numerous fan cooled prosound amps with that kind of power.
IB subwoofer FAQ page
"Complicated equipment and light reflectors and various other items of hardware are enough, to my mind, to prevent the birdie from coming out." ...... Henri Cartier-BressonComment
-
Not a lot of pro amps will bridge into two ohms. Is this a dual-coil sub where you can wire the coils in series to get to 8 ohms?
I'm running a pair of dual-driver subs wired for 2-ohms per sub with a Crown K2 in stereo mode at 1250 w/chan. It would bridge to 2500 watts into 4 ohms, but not two ohms.Comment
-
It's a tc sounds dvc 4 ohm per coil .Comment
-
Is it possible to run 2 seperate channels to a dvc sub as long as it's a mono input?Comment
-
Yeah, if you can get it really cheap and need a ~500w/2 ohm amp, than the BK might be a good choice in a fanless amp. Mine work fine, but I get the one I use on a sub almost free as part of the kits.Comment
-
What do you guys think of the behringer europower amps? I've seen good reviews of people using them for subwoofers in home audio applications.Comment
-
Hi All,
I'm building a new subwoofer using the SoundSplinter RL-R15 and Behringer EP2500.
There are two choices for the subwoofer 2ohm and 4ohm, but not sure which one to choose.... ...what benifit will I get using a 2ohm over the 4ohm? Becuase I would think the 2ohm would... -
While researching amps, I stumbled across this fanless model. Any thoughts on it? Does anyone know of anyone using it?
Buttkicker BKA1000-4A -
Sorry for the terribly noobish question but in making the sonotube project is there a benefit or a downside in choosing either a Dual Voice coil or a single? I ordered the 15" TC Sounds dual vc and now am wondering if I made the right decision. I know I would have more wiring choices and resistance... -
Has anyone build the Switchable Monitor Statemens? I was wondering if there is that much difference in the speakers performance vs placement. Does anyone have any photos and/or recommendations for the switch setups (beyond the circuit drawing). I plan on starting with the monitors as part of a 7.1... -
I have an external amp I would like to use with my RX1050 stereo receiver - using the RX1050 as a pre-amp. I am using the pre-out to connect it to the amp and it is working well. However I cannot get the 12 volt trigger to work. Does anyone know what sort of plug the 12 volt trigger out requires? My...
Comment