So I just purchased the RF-83's and have had the Sony for a couple months now. Before the 83's i was running some old Bose speakers, just til i saved up enough for these ones...anyway, I'm getting some static when the receiver is turned up past about -10 dB (which I will add, is very loud, but some of the PS3 trailers are recorded very softly...so I usually watch them at -5). Right now I'm using a friends of mines Monster M1.4s bi wire, just til i can buy some Cats...which is my next purchase, so i doubt its the wire. Anyone have an idea what this could be from? Is it just the fact that these are very accurate speakers being used with a receiver?
I will add that I'm using a Belkin PUREAV pf-60 power thing and that the Bose speakers never gave me any feedback, if thats what this noise is.
And one other thing. I have read that these speakers can drop quite a bit below their nominal impedance of 8 ohms. I haven't had any problems with them using this receiver nor have i measured the impedance but i have the option of setting the Sony for 4 ohm speakers vs what I have it set at right now, 8 ohms. Would this be better or should i just leave it alone if its working and not causing any problems?
Thanks Guys
I will add that I'm using a Belkin PUREAV pf-60 power thing and that the Bose speakers never gave me any feedback, if thats what this noise is.
And one other thing. I have read that these speakers can drop quite a bit below their nominal impedance of 8 ohms. I haven't had any problems with them using this receiver nor have i measured the impedance but i have the option of setting the Sony for 4 ohm speakers vs what I have it set at right now, 8 ohms. Would this be better or should i just leave it alone if its working and not causing any problems?
Thanks Guys
Comment