I'm BI and proud!

[ht_addict]

Not in the sexual sense you perv's. Thanks to Andrew and his talk on Bi-amping I figured for the $50 in speaker wire and banana tips I needed I'd give it a try. I used 4 of 5 channels on my 1095 to Bi-amp my L/R, the remaining channel was for the center. The rears were run off my Yamaha RX-V1400 that I'm using as a pre/pro. Speakers are connected by AR Master Series 10AWG copper/silver coated. Initial impressions are really good. Soundstage is bigger, cleaner and clearer. I'm hearing more detail than I heard before in movies. Compared to the bi-wiring I tried this is a bigger improvement. If you have the extra channels try it, you won't be disappointed.

ht_addict

[rotel_klipsch]

Bi-amping

If your not using an active crossover, you really haven't experienced all the benefits of BI-Amping. It should be as much or more differance then going to seperate amps vrs. the bi-wire... I know I'll never go back...... :T ;x( :agree:

[Andrew Pratt]

Hey just happy to bring someone else out into the open...soundstage that is :B