Rotel RCD-1570
Hello! Bought Rotel RA-1570, Rotel RCD-1570 and Rotel RT-1570. Satisfied and happy. It Was. I decided to update the Main Software Rotel RCD-1570. I did everything in the instructions. But when click the "Send Upgrade Request" button and the front panel display of the unit should turn off - the process stopped. I tried and desktop and laptop. I tried more than 10 times. No results. Rotel RCD does not turn on and don't respond to the power button. Help can be someone faced with a similar problem.
-
-
Hi Hornet,
Sounds like something interrupted the update process. Here are some instructions for forcing the player into the normal operation mode. Afterwards, you can try updating again.
"Connect to the unit with the Rotel YModem Upgrade Manager program, and follow the normal upgrade steps (Select COM port, click CONNECT, select the upgrade file, then hit SEND UPGRADE REQUEST). At that point hitting the RESTART button may force the Rotel to reset back to normal operation."
Regards,
Patrick Butler
B&W Group North America
-
I would like to share my 2nd upgrade experience with you so hopefully you would not run into the same issues I had. I have a Rotel RSX-1057; however, the issue described below would apply to any upgrade as it was not a Rotel problem.
Firmware: (1057)
my system = 2.1.2
... -
I just hooked up my rotel system yesterday. Running a 1068 with a 1075 amp. It was an upgrade from a Denon AVR-3300. I do not beleive the difference in Music this makes. I just realized how much, I am missing out. So, know I want to upgrade everything, as I am in love with this system. Now, this... -
I’m very new to home theater and higher quality audio components. I must admit I don’t know much about audio equipment. I often can’t follow some of the conversations on this and other forums when they get very technical. I don’t even have a good understanding of how separate components fit... -
Hello,
I currently have a stereo system which consists of a pair of B&W 703s, which I am powering by a Rotel RX-1052 -- which is awesome for a 2 channel receiver, but I believe that I could get much more out of my 703s if I went to separates.
I listen to quite a bit... -
Well, it's been almost 2 months now that I've lived with both my Rotel RSP1098 and my Parasound C2 and the time for deciding which I'm going to keep is almost at hand.(not that I HAVE to decide now for some reason, but I'd hate to end up with 2 processors permanently)
I actually own both of them,...
Comment