Just wondered if others know an easy solution for a 'loose' vol. knob? I see these knobs - balance, vol. etc - all fit to their respective spindle by allen-key screws...but I think this particular screw's tight. Presume wear is to blame in this case. Any thoughts? Ta.
Volume knob receiver rx-1603
Collapse
This topic is closed.
X
X
-
If there's an allen key screw, loosen it and pull the knob off. Inspect it for wear, and improper installation, then reinstall it and tighten the screw.
If there's no screw, the knob just pulls off. Pull it off and see if the shaft is sturdy or loose. The nut securing the shaft to the chassis could be loose.- Bottom
Comment