I have a RSX-1057 and a RMB-1070 to amp the main. Can I bi-amp the speakers with the main channel outputs from the receiver? The receiver output is 75 wpc while the 1070 is 125 wpc, would this be a problem? And last, which amp should be connected to which speaker input? Is it better to send more power to the highs or to the sub?
-
I was planning on using an RSX1057 as a processor with an RMB1077 hooked up to a pair of B&W 804s and a HTM3s. Orignally I thought I would biamp and biwire the L and R fronts using 4 channels of the RMB1077 while using the remaining 3 channels to drive the center and back surrounds.
... -
I have N804's and HTM-2 up front. I acquired three amps second hand, to use one for each speaker. On advice of my B&W dealer, I set up the amps each with their own custom-made Y-cable. The left pre-out goes to one amp in both L & R channel. That amp is wired to the left N804 in a passive bi-amp... -
I have N804's and HTM-2 up front. I acquired three amps second hand, to use one for each speaker. On advice of my B&W dealer, I set up the amps each with their own custom-made Y-cable. The left pre-out goes to one amp in both L & R channel. That amp is wired to the left N804 in a passive bi-amp...
-
Dear,
Thanks all for the great help you have provided. This forum rocks!
A new problem and I seek your help again. I have hooked up the Bluray player to the HDMI input of the Rotel RSX1057 and an HDMI out from the receiver is connected to the LCD TV. I am able to get the... -
I am considering purchasing a second Rotel 1095 unit to biamp two 1095 units (2x 200w x 5) which would allow me to biamp my center and two fronts (six channels) and then use a single channel for surrounds and rears. I was thinking of upgrading the fronts by adding a 2 channel amp while now getting...
Comment