It's not convenient to take the cover off and look. Where are the two transformers located?
-
-
I could only find a picture of the old version, where the two transformers were side by side in the front of the unit. The newer design with the better speaker terminals has one transformer in the center front, one in the center rear. Both design have them under all the capacitors, so you still wouldn't see much pulling the cover.
Kevin D. -
My Speaker Terminals on the 1090.
I have four terminals, red and black plastic left speakers and the same for right speaker. I think that's old design. What year did the new design come out?Comment
-
Not sure, maybe around 4 years ago??
Kevin D.Comment
-
Thanks Kevin
Thanks Kevin.Comment
-
Dear friends,
I came home tonight and my RB-1090 is dead. No lamp, no output.
So I figured it might be the fuse. However I couldn't locate the fuse immediately and I thought it might be a good idea to ask you guys first before I start.
So, if anyone of you knows...... -
I'm sure everybody will be excited to know that the new Classic gear from Parasound is now available to order. They released it this week with much anticipation.
A typical 7 channel setup will consist of the 7100, 5125 and 2125. This will cost $5,500 MSRP and be fully THX Ultra II Certified.... -
Hello everyone here. I'm new posting here, although I've been
reading on here for a long time, I decided to finally post on
here.
A ways back I was in the market for a new amp and did much
reading at several forums, reviews, recommendations and all... -
I did this review for the Klipsch forum of how wonderful
the Klipsch RF-7 and Rotel RB-1090 sound together.
The Rotel RB-1090 is a superb amp with the Klipsch
RF-7. Klipsch are very revealing speakers with any
shotcomings from an amp and the Klipsch will let you
know... -
Does anyone know the diameter of the hole in the shaft on the 1090 terminals?
Comment