rmb-1075 i just purchased one i need a measurement

[boxer82003]

the rmb-1075 has rubber feed on it if i remember correctly can they be removed if so how tall is it without them

[Kevin D]

http://www.rotel.com/support/files/cad-drawings/Rmb-1075%20Model%20.pdf

Quick glance, roughly 1/2". I'm not sure if the bottom is perfectly flat, and probably wouldn't want to rest it there is so. Probably some thin felt cushions.

Kevin D.

[boxer82003]

thanks i will look at the link

i have 7 1/4 inches rotel says its 7 1/4 tall so it gonna be tight

[H.Donald]

Hmmm,I think you might need a little more ventilation even if it fits.

[boxer82003]

Hmmm,I think you might need a little more ventilation even if it fits.

there is a support bar 1 inch lower then the top of the shelf so i should have an inch on top and lots on the fron sides and back

[Kevin D]

Good luck, you should be able to make it work.

Kevin D.

[Destruction]

Hi boxer82003,

The RMB-1075 uses the convection cooling method for the heat sinks i.e. the warm air vents from the top whilst cool air is drawn in from the bottom. If there is no cool air available at the bottom of the heatsinks you may find that the amp overheats and goes into protection, or worse, damages one of the output stages.