the rmb-1075 has rubber feed on it if i remember correctly can they be removed if so how tall is it without them
-
Main Linn Ninka
Center Linn AV5120
Rear Linn Ninka
Sub B&W ASW 650
Processor Rotel RSP-1570
Amp Rotel RMB-1075 -
http://www.rotel.com/support/files/c...20Model%20.pdf
Quick glance, roughly 1/2". I'm not sure if the bottom is perfectly flat, and probably wouldn't want to rest it there is so. Probably some thin felt cushions.
Kevin D. -
thanks i will look at the link
i have 7 1/4 inches rotel says its 7 1/4 tall so it gonna be tightMain Linn Ninka
Center Linn AV5120
Rear Linn Ninka
Sub B&W ASW 650
Processor Rotel RSP-1570
Amp Rotel RMB-1075Comment
-
Hmmm,I think you might need a little more ventilation even if it fits.Comment
-
there is a support bar 1 inch lower then the top of the shelf so i should have an inch on top and lots on the fron sides and backOriginally posted by H.DonaldMain Linn Ninka
Center Linn AV5120
Rear Linn Ninka
Sub B&W ASW 650
Processor Rotel RSP-1570
Amp Rotel RMB-1075Comment
-
Good luck, you should be able to make it work.
Kevin D.Comment
-
Hi boxer82003,
The RMB-1075 uses the convection cooling method for the heat sinks i.e. the warm air vents from the top whilst cool air is drawn in from the bottom. If there is no cool air available at the bottom of the heatsinks you may find that the amp overheats and goes into protection, or worse, damages one of the output stages.
Best regards,Comment
-
I've currently got an RMB1075 and an RSP1066 with Definitive Technology speakers. I've ordered some new towers for the main L/R (Def Tech 7001SC's) which should be a considerable upgrade from my current towers (Def Tech ProTower 400's). I am going to move my ProTower 400's to the rear.
... -
As the topic says...
Is it possible to bi-amp RMB1075 with zone 2?
I have RSP1068/RMB1075 kombo and i have connected Front Left/Right as usual... but what happens if i connect zone 2 Left/Right output to RMB1075 Left/Right surround and bi-amp the speakers?
... -
Hallo,
I have in my head the Rmb1077.
It has a sense to change rhe Rmb1075 with Rmb1077?
My set is Rsp1068+Rmb1075+Rb1092
speaker B&W803s mains (Rb1092), Htm7 center biampli, 703rear with Rmb1075 (750sub, pioneer507XD, denon3930,HD toshiba Ex1)
... -
Hi
I am looking to upgrade my speaker to 804S and HTM4 using the Rotel RMB1075/RSP1068 to drive it. I normally listen to CD (bypass mode) and DVD concert music. Anyone know whether he rotel rmn 1075 can drive the 804S. I also have a REL 201 sub in my system. When I listen to the 804S speaker... -
Hi Guys ,
I need some advice as to what is best .
I want to add another amp to my RSX1065 to run some B&W604S3's
Do I :
1.get RB 1080 and biwire the 604's(200w per speaker)
2.get RMB1075 and biamp the 604's (2x120w per speaker and leaves one channel spare...
Comment