RSP 1068 not passing HDTV

[Nolan B]

There is a clear issue with my 1068. I have my cable box hooked up via component to my 1068. When on HiDef channels the picure blacks out every 30 seconds or so.

An obvious fix would be to plug my cable right into my TV, but if I do there I wont be able to access my OSD from the rotel unless I run another 3 meter component cabl from my 1068 to tv...which I shouldnt have to do.

Anyone have any suggestions?

[Kevin D]

Any component source greater then 480i needs to have progressive set to 'YES' in the setup menu. You probably missed that step.

KEvin D.

[Nolan B]

Any component source greater then 480i needs to have progressive set to 'YES' in the setup menu. You probably missed that step.

KEvin D.

yes i did miss that. I will give that a shot...thanks.

do setting progressive to yes do any processessing to the video signal?

[Nolan B]

ok...that worked. As long as the OSD is off the HDTV passthrough is ok.

Thanks

[Kevin D]

Setting it to yes actually does 'less' to the signal. As you found out, the OSD only works when the signal is 480i. Otherwise it tries to put it up and messes up the signal.

Kevin D.