I'm not happy with the PQ I'm getting from satellite high def. My satellite receiver's output is going into my Rotel via component and is then going out from the Rotel into my front projector via component cable. Someone on another board (AVSforum) suggested that my problem may be my receiver. He contends that at some point during RSX1056 production the video switching card's bandwidth was increased from 10K to 100K and he claims he has an older RSX1056 that still has only 10K of bandwidth. Is this true? I purchased my 1056 new from a local retailer 3 months ago, but presumably it could still be an older unit that sat in the distributor's warehouse for a while. If true, does anyone know the approximate serial number at which point the upgrade was implemented? I guess I could test it empirically by re-routing the component feed direct from satellite receiver to PJ, but pulling components from my birds nest mess of a rack is a pain, and I'm a bit lazy.
-
-
The 1056 has always had 100K, more than enough bandwith to handle HDTV. Th 1055 and 1066 made the switch from the lower bandwith (10K) to the higher bandwith (100K) during their run.
Scott -
Check and make sure the sat unit is set to output 1080 or 720 (whichever is best for your TV). Also make sure you're on an HD channel.
But as far as the 1056, if it's effecting the signal, something is broke..
Kevin D.Comment
-
Anyone know if the RSX-1065 has the same low bandwidth video switching problem that the RSP-1066 and the RSX-1055 had and if it does, at what point if any, was it upgraded to the new 100mHz bandwidth that the current production run of RSP-1066s enjoy? -
I always thought that the rsx1056 should not be used with 4ohm speakers.Atleast that's what rotel told me a while back when i was inquiring about dynaudio speakers,so i ended up with B&W 603s3's/lcr600(really liked them anyway).Well i have upgraded my speakers to a System Audio setup(sa1750/sa720av/sa505's)these... -
Is the better choice the RSP1068 or RSX1056 for pre-amp duty?
I will add the RMB1066 (in bi-amp mode) or the RMB1075.
I am upgrading from a denon1804 to drive B&W700series in 5channels only (no sub yet)
Being budget limited, choosing the RSX1056 allows me to... -
Those of you who have the rsx1056 with a dvd-a/sacd player how did you do the setup in the rsx1056.I understand that settings are done thru the dvda/sacd player but how about the receiver.I was looking at my receiver last nite and i beleive you need to go in the multi setup options but didnt see real...
-
I have an rb1050 just laying around right now and was contemplating adding it to my rsx1056.The rsx1056 is rated at 100x2,the rb1050 70x2.Would it even be worth the trouble adding the 1050 to the rsx1056 for the fronts.Would i notice anything being the amp is rated lower.I just hate to get to the rear...
Comment