Has anyone replaced the stock power cord that comes with the RDC-7 with an aftermarket power cord ? If so could you share your impressions.
-
Well I've had my NAD M51 for over a week so far using it everyday and I figured I'd post up some impressions and opinions on the DAC. First I will say that my unit is a factory (NAD) refurbished which saved a few hundred bucks on the unit. I ordered it from SpearIt Sound up in Massachusetts and they... -
Quick question. What is the best way to secure the power cord in the socket of my Rotel RMB 1565 amp? Everytime I need to move my cabinet the power cord seems to lose contact with the socket and the amp shuts off. I'm finding I need to turn off the amp, and then reach in and push it in to get a good... -
I have two power amps one has a built in power off and on toggle that my pre amp controls but my Class A Musical Fidelity amp does not. Given the Class A design this amp is sucking a lot of current from the wall and I wished I had a way to turn it on and off without resorting to an X10 switch or some... -
Has anyone tried upgrading the power cords on their gear? I did, using a DIY formula they work awesome and cost a fraction of what expensive aftermarket cords cost.Check out this site for more info http://www.venhaus1.com/diymains.htm -
Based on some discussion in another thread, I went ahead and ordered a VH Audio Flavor 3 power cord to replace the stock cord that came with the 1066 pre/pro. However, when it arrived today, I noticed that the cord had a three-prong female receptacle with a three-prong male receptacle versus a two-prong...