Can someone point me to the correct cable/adapters on partsexpress or radioshack.com to use to control my c2, A52 and t3?
Thanks.
Elmer
Thanks.
Elmer
-
-
The C2 output uses a 3.5mm plug. The A51 and T3 in/out uses 2.5mm plugs
You need one cable with a 3.5mm plug in one end and a 2.5mm plug in the other end. (C2 to T3). Then you need another cable with 2.5mm plugs in both ends (T3 to A51)
The Parts Express items you need are:
3 090-328 2.5mm mono sub mini plug $0.87
1 090-290 3.5mm mono mini plug $0.29
1 100-124 24 GA clear wire 50 FT $2.95
Of course this requires that you have access to a soldering iron since these connectors require soldering...
Peter -
thank you sir!Comment
-
Peter,
Is there a better source for cables that are already complete?
Thank again,
ElmerComment
-
Elmer did you loose yours that came with the gear? :E :E
Brent Huskins
Media DesignComment
-
Brent,
Yes I misplaced mine during my buildout.
ElmerComment
-
Yeah, I was going to say, my components came with the cables. I can't remember if it was the C1, A51, A21, or all of the above.
CHRIS
Well, we're safe for now. Thank goodness we're in a bowling alley.
- PleasantvilleComment
-
The C1/C2 come with two 3.5mm<=>2.5mm cables. All other components come with one 2.5mm<=>2.5mm cable each.Originally posted by Chris Dotur
PeterComment
-
Well I am finally taking the plunge into SACD and DVD-A with the help of Outlaw's ICBM. What I would like to do, instead of using the supplied cable, is buy a higher quality cable with a DB-25 connection on one end and MALE RCA plugs on the other. This would allow be to plug the cable directly into... -
I'm wanting to use some Eichmann bayonet plugs in my system. I've done a bit of looking into them and they seem to be a very innovative design with a firm ethos on how the transfer of the audio signals should be undertaken.
They say in their literature to silver solder the speaker cable... -
First off, hi HTGuid community! The interaction in this forum is unprecedented in it's friendliness and willing assistance, so I have come out of lurk mode to pick your brains.
I am building a small portable system for my father based off of the B3S full range driver design... -
I want to make a subwoofer cable with a RCA connector and a 1/4 mono plug. I am planning to use a old MonsterBass™ 300 Subwoofer cable and use the one of the RCA on it and cut an end off and solider a 1/4 mono plug on the other end. Now the question is what a good 1/4 mono plug that will fit on this... -
(I'll be making more various posts here in the Club as I get time to share info. Let me know if you guys get tired of me always posting--from monitoring the Club, though, looks like there's still lots of "lurkers" who do use the info, if nothing else)
I recently sent my...01 April 2008, 00:27 Tuesday
Comment