my question was is it better to connect individual speakers onto its own channel? I mean 1 channel has 100watts and If I put left and right speakers on that 1 channel.. is it worse than putting say right speaker on channel 1 and just that 1 speaker gets its own 100w channel and left speaker on 2nd channel and each channel is labelled A(channel 1), B(channel 2). So I put the settings on channel A + B to be active.. or is it better to put both speakers on channel 1 left and right and just enable Channel A on... sorry guys I wish there was a chatroom instead.. cause I have bunch of questions.. after the tweeter went out just freaked out...
-
I was hoping someone could help me with my Rotel RSP 1098. Although its old, I have fell in love with the sound that it has produced. I am using this in combination to my RMB 1095. I use the multi input channel to connect my Oppo 103D to the RSP 1098.
One day, I noticed that the center...24 October 2015, 07:44 Saturday -
Hi guys,
I've got a Rotel RSX-1056 receiver with 100watts in 2-channel mode. Is this good enough for the 805's considering they are rated at 50-120watts?
I could power them with a Rotel 1092 500watts power amp also. Is this overkill? Or would the extra power be beneficial?... -
How to connect 2 Subs to a RSP-1098?????
--------------------------------------------------------------------------------
Hi Everyone,
I have a Rotel Processor RSP-1098 and I have just received my second Sub which are the ASW 850 and I want to connect them:... -
Hi Everyone,
I have a Rotel Processor RSP-1098 and I have just received my second Sub which are the ASW 850 and I want to connect them:
1) Do I connect sub 1 in The processor under Sub 1 Input and the 2nd Sub in the Sub 2 Input??
... -
As per Dre J's bass management reports and solutions, the best way to connect the 1066 and an ICBM (not including 5.1 inputs) is to set the sub to "off" in the 1066 menu setup, sending LFE bass to the front channels, and then letting the ICBM sort it out. The downside to this setup is the...
Comment