Do you guys think that there would have been a benifit if B&W had used dual 150mm (6”) Kevlar cone FST midrange drivers in the 803s and up?
Maybe in the centre channels aswell?
Maybe in the centre channels aswell?
-
-
Why should they? The only positive reason to use more than one is to increase power handling. The downsides include bulk, weight and driver interaction that screws up polar radiation patterns.
So, unless there is a power handling problem, there's no good reason.
KalKal Rubinson
_______________________________
"Music in the Round"
Senior Contributing Editor, Stereophile
http://forum.stereophile.com/category/music-round -
I would have to agree. Adding another driver in the setup is much easier said than done, it changes a lot of the parameters.Originally posted by Kal Rubinson-JoeComment
-
fair enough.Comment
-
Hi,
I have noticed the 804s/803s/803d/802d/801d/800d all use the 150mm (6”) Kevlar cone FST midrange driver. Are the crossover for this all set to be the same? Do they all run in the same range?
What about the 805s the 6.5" Kevlar, what frequency does it run at?... -
Someone here asked about the Dynaudio dual tweeter configuration vs. comb filtering. I had a chance to see them in action at HE2006 this weekend...the tweeters seem to share a common highpass, but the upper tweeter is rolled off on the top end...no surprise. This show gave me my first opportunity... -
All,
I have had this design in mind for almost 5 years but thinking of pulling the trigger now.
Here are the broad parameters:
1. Size: Roughly speaking 40" tall, 9" to 10" wide and 14" to 15" deep (so about 80 - 90 liters)
2. Woofers: Dual 7"... -
Hello all. Well after having listened to the big RS 3ways for some time I am still left wanting more bass, so I have decided to stop messing around and use dual 15'' bass bins to get some real kick in the chest action. I am looking at the Dayton Series II, ST385-8 with:
Power handling: 300 watts... -
Hi everyone!
I have been playing around with Unibox and have a few questions about some port length trade-offs. First, I have actually heard this driver in the 3" port configuration, and there was not any problems with the port configuration, i.e. no port chuffing or obvious midrange...
Comment