Hello All, I have a question concerning the Behringer A500. It says in its specifications that when driving 8 ohm speakers it produces 125 watts per channel. It seems to me that this is very low. So an Onkyo receiver that specifies 135 watts per seven channels at 8 ohms, actually puts out more wattage then these Behringer A500 amps. So buying four of these amps to run a 7.1 system would just be a waste and would be better off running them with an Onkyo 7.1 receiver? Please help.
Behringer A500
Collapse
This topic is closed.
X
X
-
A 15 WPC difference will not impact the sound much. The two amplifiers will sound different, but the wattage is probably not a factor. A better place to start may be to get some information on what else is in your system. What speakers are you using? How big is your room? What listening levels do you expect to be operating?Danish- Bottom
Comment
-
I'm pretty sure the speakers will be (7) Definitive Technology in wall UIW RLS II speakers. They are rated at 50-350 watts. Here is the link:
Our obsession to build best-in-class audio products all starts in the home and is forever aligned to exceed your unrelenting expectations. Shop here.
I will also have one 15 inch 1200 watt sub along with a 12 inch 1200 watt sub for the low end. I was thinking of running (4) of these A500 amps for the (7) in walls, but then I looked at the wattage rating and saw they would only put out 125 per channel at 8 ohms. If the speakers are able to handle 350, I would like to go a little more. Unless the 125 watts from these A500 amps is pure clean power in respect that it may be twice as much as the receiver? I guess I could go the real expensive route and buy one A500 per speaker? I dont know.- Bottom
Comment
-
There may be some (minor) advantage in having separate amps ony from the standpoint that you will have 4 power supplies instead of 1 with the receiver. As far as the needed power, the speakers are showing to be 92 dB efficient, which isn't bad. You might look into the Emotiva amps some people have been buying. There are numerous options you have, but I wouldn't base the final decision on a few WPC either way.
Also, I would think twice about getting 7 of those speakers. Possibly go with 3 for the front (for which they are designed) and then look at the RSS II model for the surrounds.Danish- Bottom
Comment
-
Why would you say going with (4) Rss II for the rears, because of cost? I dont want Bi Polar surrounds. I have enough distance between me and the sitting area where I dont have to. Anyways, dont you think seven of these woudl be awesome?- Bottom
Comment
-
Originally posted by rf5000So an Onkyo receiver that specifies 135 watts per seven channels at 8 ohms, actually puts out more wattage then these Behringer A500 amps. So buying four of these amps to run a 7.1 system would just be a waste and would be better off running them with an Onkyo 7.1 receiver?
The Onkyo receiver, like most other mass market AVRs, will not deliver their rated power into all channels driven simultaneously, nor are they expected to. You may get the rated 135 watts from two channels driven simultaneously, but as more channels are driven, total output will drop. The power supplies are just not capable of delivering the necessary current to sustain full output in all channels at the same time.
That is fine though, since in real world use, you will never find all channels being called upon to deliver large amounts of power at the same time.
- Bottom
Comment
-
Originally posted by rf5000Hello All, I have a question concerning the Behringer A500. It says in its specifications that when driving 8 ohm speakers it produces 125 watts per channel. It seems to me that this is very low. So an Onkyo receiver that specifies 135 watts per seven channels at 8 ohms, actually puts out more wattage then these Behringer A500 amps. So buying four of these amps to run a 7.1 system would just be a waste and would be better off running them with an Onkyo 7.1 receiver? Please help.
I run two a500's. The speakers are 4ohm and I get tons of great sound out them. The RCA inputs hum, I use the TRS input.
KGHere is my LCR "Trio". Way to go guys !- Bottom
Comment
-
Anyone know of QSC amps or are they just for PA systems? Dotheymake high quality sound amps for home theater? Also, I was looking at other mutichannel amps for sale. Would yourecommend running say four of these A500 amps or like a Carver or Adcom multi channel amp?- Bottom
Comment
-
I have a couple of A500 amps and they work well. Power delivery is solid into 4 or 8 ohms. You can even bridge an amp with an 8 ohm load, and have higher power as a mono-block. I've done that with a dual-woofer sub, just to run one cable rather than two (two 4-ohm drivers in series). The value is pretty hard to beat. Other pro type amps will pretty much all have a cooling fan, so the convection only cooling on the A500 is a bonus. I like the volume knobs at the front. Using the balanced inputs is a good idea.- Bottom
Comment
-
Originally posted by rf5000Anyone know of QSC amps or are they just for PA systems? Dotheymake high quality sound amps for home theater? Also, I was looking at other mutichannel amps for sale. Would yourecommend running say four of these A500 amps or like a Carver or Adcom multi channel amp?
KGHere is my LCR "Trio". Way to go guys !- Bottom
Comment
-
Originally posted by Glen BCheck with HT Guide Forum Member whoaru99. He runs QSC amps.
Yes, it's true.
Two PLX 2402s for surround and back speakers and two PLX 3402s for fronts and center.
They've been modded with quieter fans. Other than fan noise concerns, which I knew going in, I'm very satisfied with them and they're not in any danger of being replaced any time soon. :T
To me, the amps sound great plus I have all the power I need...and then some.
There are some things which are impossible to know, but it is impossible to know which things these are. :scratchhead:
----JAFFE'S PRECEPT- Bottom
Comment
-
Originally posted by whoaru99Yes, it's true.
Two PLX 2402s for surround and back speakers and two PLX 3402s for fronts and center.
They've been modded with quieter fans. Other than fan noise concerns, which I knew going in, I'm very satisfied with them and they're not in any danger of being replaced any time soon. :T
To me, the amps sound great plus I have all the power I need...and then some.
Here is my LCR "Trio". Way to go guys !- Bottom
Comment
Comment