I am trying to decide what S-video switch to buy but I have a different situation then most switches are built for. I need to be able to switch the output from my reciever two either my TV or my projector but most switches only have one output. Would this (http://www.kvms.com/products/SE-SV-2-LC.asp) be able to work opposite of what its supposed to do?
-
-
Don't look for a switch, look for a distribution amp. This one will work fine:
Kevin D. -
Kevin, This is a very handy device. I have two becuase the first one failed almost imediately. I opened it up to find the whole row of capacitors bulged and leaking.
They are cheap, In order to rely on it I will recap the bad one, I always need more outputs.JimComment
-
Hi guys, just a quick question on how the RB1080 (with 8 speaker terminals on back, not 4 ) switches from "A" speakers to "B" speakers?
Is there a switch on the front or back panel?
Rotel's website does not show any switches on the unit for A/B speakers,... -
I know a few of you are building Statement Monitors and I though I'd share a source for the 3PDT switch I call out for the switchable BSC version.
http://www.surpluscenter.com/item.as...-3141&catname=
I bought a pair of these a couple... -
With all the new audio and video formats, many people find themselves with more than one transport. They have a choice of buying a new HDMI 1.3 receiver (most prepros don't support HDMI let alone 1.3) or going with analog audio from the transport. The problem is most prepros only have one 6-channel... -
I have two sets of 5.1 speakers in adjoining rooms, fed by a single AV receiver. Currently I have three Russound A/B switches that I use to switch between the room A or room B speakers. This works fine except I would like to be able to perform the switch from my remote.
I have searched...17 January 2008, 11:02 Thursday -
Any ideas what could be setting them off, or am I just best off to replace with Lutron? I have some Lutron, these are the only 2 X10 wall switches I have, annoying the crap out of me.
One seemed to have a slider at base, and I slid it over and it has not come back on since. But my two...
Comment