Wiring for Shakers

[freon]

I got some of the Aura shakers 4ohm 25watt.

There is six total that I have 1 for each seat.

I want to power them with an old H/K reciever in stereo mode its rated at 75watt@80hm or 100watt@4ohm FTC.

What would be my best option. I was thinking of wiring Three in series and put each set to one channel.

Or should I put 3 in series than parallel them all on one channel?

Im not sure how to figure the resistance when putting more than 2 in series.

[Chris D]

I have six Clark Synthesis tactile transducers and had similar questions. I don't know about the Auras specifically, but they are lower powered than the Clarks for sure. I REALLY don't think you want to do anything like wire them in parallel, though. What I did is have my tactile transducer line-level output come from my Parasound pre/pro to an Audio Source monoblock 250W amplifier that powers one Clark Synthesis TT. The Audio Source amp has both a line input and a line output, so I used the line output to send the same signal to the next mono amp to power the next TT, and so on. So each TT is powered by its own mono channel amp, and the amps are daisy chained together with the line signal. This is the perfect solution...