ı am very new here and ı wonder if possible to go deep tight and loud basses under 70 herts in less than 1 liter enclosures ,sound should be clean ,clear and natural very less comprimise desired.it might not be high - end but better than many hi - fi,ı know its not possible to do all in one but what can be the closest point you can get .ı am thinking to use peerless tympany ne 65 full range driver in 11 cm diameter hdpe with 1 cm thick wall enclosure .has anyone used this driver and any comments wellcome.
-
I'm going to build the TriTrix MTM speakers, and have a question about the enclosure choices (the article at Curt's Site details three choices, sealed, vented and transmission line).
The speakers will be incorporated into my eventual 5.1 set up that is now a 3.1 system with a Velodyne... -
I have decided to build a subwoofer based off reccomendations from SteveCallas and others on AVSforum. Here are the specs:
--Sound Splinter RL-P15 D2 (dual 2 ohm voice coil [wired in series for 4ohm load])
--Crest CPX900 (bridged 4ohm for 900 watts)
--260 effective liter... -
Hello everybody. Love this site, btw. I just spent an hour looking for something similar enough to my situation. No luck, so here goes.
gawd... I just looked at this and it is waaaay too long ...
I have an "entertainment center" that I hope to install in-wall... -
Just received my 305 and now in the process of tweaking my setup. I was hoping for some help, advice or general commentary on a few things I currently am trying to setup. For a better idea of my environment, I have B&W 804's with a B&W HTM2 for my mains and center. I also have a FS12 Velodyne...15 February 2002, 16:51 Friday -
Have a B&K AVR305 that I use for 80% music and 20% movies. I have been very happy with the performance on movies, but feel that there is room for improvement on music. Thought about purchasing a separate 2 channel amp for my mains, but don't want to spend the extra money right now.
...