I posted this on the electronic devises forum b/c I have the Harmony remote, but may be it should be here. Can anyone offer any suggestions?
I have the Harmony H680 remote and I would like to use it to control my computer and my X10 lighting. If I were to get the USB UIRT to receive the IR commands from the Harmony, I assume I could use Girder and control winamp, etc. But, how would I go about setting something up to send out the RF commans to the X10 controls. I have the serial firecracker adaptor for X10... can that be used with Girder and USB UIRT to handle that aspect?
My setup is in my living room. I would like to keep my ATI RF remote control in my bedroom since I can control the computer from back there and use the Harmony in the living room via IR. If I hooked up the Firecracker serial adaptor, ATI remote USB receiver and USB IR receiver all at the same time on the computer, will I have conflicts?
AJ
My setup is in my living room. I would like to keep my ATI RF remote control in my bedroom since I can control the computer from back there and use the Harmony in the living room via IR. If I hooked up the Firecracker serial adaptor, ATI remote USB receiver and USB IR receiver all at the same time on the computer, will I have conflicts?
AJ
Comment