This Thread has been moved to another forum. You can read it here http://www.htguide.com/CFBoards/inde...Forum=17&CFB=1.
-
Ok I hope to try this as soon as I can but it may take me a week or longer to find the time...but for those with 1055's here's what you need to do to remove the bass redirect on the multi channel inputs
Find the Terminal board marked 016V-1339V301 and disconnect resistors RW 167 and RW... -
I have an older RSX1055 with original version of firmware. Recently hooked up two CB speakers and utilized the redirect feature in the on display menu. Initially the RSX1055 would reset the redirect back to front speakers. :cry: I called Rotel and was told to update the firmware. :roll: Then I called... -
Would the addition of this power amp been an improvement on the RSX1055. And if so driving which speakers,bi-amping or other suggestions.
Must Kill All Humans -
Recently purchased the Philips DVD963SA player to go with my RSX1055 receiver. I run my speakers as small on the receiver and was wondering if I should do the same in the DVD players setup for multi input?
Also I have noticed that when I change from the Co-ax input (receivers decoder),...23 June 2003, 04:24 Monday -
I had a chance to audition a Denon 2900 with the Rotel RSX1055. I was very impressed by red-book playback as well as SACD & DVD-A. I realized after returning the 1055 that the Denon had been set to output only 16 bit for DVD-A so when I listened via the coax cable I was not at full resolution. Can...