1055 - Stand-by Mode

Collapse
This topic is closed.
X
X
 
  • Time
  • Show
Clear All
new posts
  • Poul
    Junior Member
    • Dec 2002
    • 8

    1055 - Stand-by Mode

    Since purchasing the 1055 I occasionally have problems powering up the unit from stand-by mode. Pressing the POWER button on the remote has no effect and only works after powering down and up using the button on the 1055.
    Has anyone else experienced this problem?

    Regards
    Poul
  • Rcovell
    Junior Member
    • Dec 2002
    • 13

    #2
    poul
    I've had my 1055 for less than a month and have not experienced the problem you describe. As long as my blue light is on, I've been able to go the full function operation with the remote control. If the blue light is off, I need to push it in at the unit itself. But, that's not a usual operation for me since the unit is installed in a glass front cabinet and the remote is used for on/off control. (The blue light is always on.)
    Have you checked the OSD for the power options? I don't know if that would make an intermittent difference, but, there are three options for power control. (page 13 of my manual) Good luck, Bob.

    Comment

    Working...
    😀
    😂
    🥰
    😘
    🤢
    😎
    😞
    😡
    👍
    👎
    Searching...Please wait.
    An unexpected error was returned: 'Your submission could not be processed because you have logged in since the previous page was loaded.

    Please push the back button and reload the previous window.'
    An unexpected error was returned: 'Your submission could not be processed because the token has expired.

    Please push the back button and reload the previous window.'
    An internal error has occurred and the module cannot be displayed.
    There are no results that meet this criteria.
    Search Result for "|||"