Hello i've changed the powercord on my rb985 to a supra lorad cable.I've installed a new power inlet on the amp with a ground pin.should i use it or not.is there any gain(improvement in the sound) in grounding the rb 985.i am currrently running it without grounding since thats how i'ts originally was constructed.
ground on rb 985?
Collapse
This topic is closed.
X
X
-
I can't answer your question directly, but one thing to check is does the Amps IEC connector (power in) have a middle earth pin? If it does, I'd use a 3 wire cord with earth, if it doesn't a 2 wire will suffice as the earth is obviously not necessary.- Mike
Main System:
B&W 802D, HTM2D, SCMS
Classé SSP-800, CA-2200, CA-5100- Bottom
-
Sorry, I mis-read your post.
If the original design didn't use a ground, then I wouldn't change the setup.
The power cord shield will still be effective if its grounded at the wall outlet end.- Mike
Main System:
B&W 802D, HTM2D, SCMS
Classé SSP-800, CA-2200, CA-5100- Bottom
Comment
Comment