Hello,
i own a Rotel RSX 1057 (center, fronts, sorrounds, sub)+RB 1050 for my rears.
I connected the rear-preouts of the rsx 1057 to the rb 1050 inputs like in the owners manual description.
In the setup of the RSX 1057 i can not find the rears (as description), just only the centerbacks, so i put them to small2...is this right?, or should i connect the CB1+CB2-preouts from the rsx 1057 to the RB 1050?
i own a Rotel RSX 1057 (center, fronts, sorrounds, sub)+RB 1050 for my rears.
I connected the rear-preouts of the rsx 1057 to the rb 1050 inputs like in the owners manual description.
In the setup of the RSX 1057 i can not find the rears (as description), just only the centerbacks, so i put them to small2...is this right?, or should i connect the CB1+CB2-preouts from the rsx 1057 to the RB 1050?
Comment