I am thinking of buying a rb-993 to save a little cash because it is a 3 channel amp. But I want the sound quality of the 1095. IS THE 993 THE SAME AS THE 1095 BUT ONLY 3 CHANNEL, or is there different "insides". I want to hook it up to my rf-7's and rc-7 (so I am looking for a the same "warmth" as the 1095). thanks rich
-
-
The 993 is more 1.5 the same as a RB-1080, which sounds a little bit better then the 1095... I think you would be fine.
Kevin D. -
I have had nothing but good experience with the 9 series amps.
My 13 yr old 980 still runs and sounds great, and I recently picked up a 990 that just was refurbished at the Rotel service center. The 990 sounds extremely good in my system.
Only concern with 9 series amps (or any other older amp for that matter) would be the condition of the caps, as they tend to wear/weaken over time. You can always have them replaced, though.Comment
-
How exactly do you replace the caps on the amp? Does it have to be sent to rotel for service?Originally posted by wkhanna
Sony kds-60a2000\Panasonic BD-55k\XBOX 360 Premium(20gig)Slingbox\Xbox(flashed) running XBMC
Emotiva UMC-1\Emotiva XPA-5\Klipsch (2)RF-7s with DeanG xover upgrade, RC-7 with DeanG xover upgrade, (2)RS-7s\SVS 20-39PC+
_____________________________
“Insanity: doing the same thing over and over again and expecting different results.” - EinsteinComment
-
Hi folks -
This is my first post and I just bought a used 993 3x200 amp through ebay after saving for a while. Since I listen to music as much as HT I needed something to take my Denon 3803 to a place it couldn't handle by itself.
First off - what's the general impression of this unit... -
Hi everybody,
I'm considering a pre-amp for my RB 1090 and RMB 1095. I am looking at Rotel RSP 1068 (used) or an Outlaw 990. I would say around 1100 bucks or under would suffice for the moment.
I considered the RSP 1069 but it is very expensive and has many issues that... -
Hi, I recently read in a home-theater magazine that the Rotel rsx1067 was their first choice in the heavy-receiver class.. How will this receiver compare to a setup with rsp1068, rb993 and rb985mkII, when it comes to sound quality, as the price for these two setups will be about the same.. -
I'm new to the forum and Rotel, I just installed a Rotel 1095 amp and 5 M*Design Eleganza (4 ohm) speakers and Godfather Sub in my home.. using my 5 year old Denon 330 as Pre-Pro ... and want to upgrade the Denon to a separate Pre-pro such as 1068 or 1098...
My question - it seems that both... -
I'm new to the forum , I just installed a Rotel 1095 amp and 5 M*Design Eleganza (4 ohm) speakers and Godfather Sub in my home.. using my 5 year old Denon 330 as Pre-Pro ... and want to upgrade the Denon to a separate Pre-pro (maybe 1068 or 1098)...
My question - it seems that both the Eleganza's...
Comment