Does anyone have the problem with this 2 ch amp running hot and clipping out?
-
Title pretty much says it all. Whenever I see a thead about a rotel component running hot I always check my 1068 and sure enough its always hot to the touch. When the weather is hot it gets hot enough where I wouldnt want to keep my hand on it for any length of time (my apartment has terrible air... -
I got this quote from another thread (thanx Aussie Geoff
). Here 2 inches at the top is defined as "good ventilation" (for the RSX-1056).
It made me wonder: how much room for ventilation do you guys use / recommend for your (pre)amps? I remember my manuals stating to use... -
I have an rb1050 just laying around right now and was contemplating adding it to my rsx1056.The rsx1056 is rated at 100x2,the rb1050 70x2.Would it even be worth the trouble adding the 1050 to the rsx1056 for the fronts.Would i notice anything being the amp is rated lower.I just hate to get to the rear... -
I built an in wall cabinet for my Rotel 1075 5ch amp, and my 1056 receiver.
Can I get some feedback from others who have done this - how much ventilation is needed??
I purchased a 120mm fan, and I plan to cut out a hole in the top of the cabinet and install the fan there.... -
This is a question for all the lucky 1069 owners out there. How hot does your unit run? The manual recommends 4 inches of clear head room. My cabinet would allow 2 inches at most, but with a somewhat open back panel.
Does any owner put the 1069 in a closed cabinet? If so, what is your...
Comment