I got my new power amp for my second zone and attempted to use the "zone" trigger to power it on and off.
If I go into the set-up area for zone 2 and define the trigger as "zone" the zone 2 amp powers up (a good thing). When I turn off zone 2 (on the 1068) the zone 2 power amp stays on (a bad thing). If I put my multi-meter on the lead for the zone 2 trigger and I get 12v all the time.
Unless my logic is 180 degrees out of sync with Rotel engineering, I think I've got a problem.
Are any of you suscessfully turning on and OFF accessory equipment?
If I go into the set-up area for zone 2 and define the trigger as "zone" the zone 2 amp powers up (a good thing). When I turn off zone 2 (on the 1068) the zone 2 power amp stays on (a bad thing). If I put my multi-meter on the lead for the zone 2 trigger and I get 12v all the time.
Unless my logic is 180 degrees out of sync with Rotel engineering, I think I've got a problem.
Are any of you suscessfully turning on and OFF accessory equipment?
Comment