HiGuys, Brand new to your forum I first have to say I have found this a great source of info over the past few months,I have always had great performance from my vast assortment of Rotel products over the years but I had a strange snag happen tonight with my RB-1090, I shut it off as per normal via the 12volt triggers on my pwr center and now I can't turn it off, the amp works fine I am assuming, a relay failed in the power on /off switch which is preventing me from turning the unit off ,Anyone else have this problem?
-
Today, I just got back from hearing the 1090 and 1091/1092 amps duke it out with the BW802D... side by side. I must say, I preferred the RB1090 by a good margin. I thought that the 1090 took better control of the 802D in ALL aspects, from the bass to the diamond tweeter. The 1090 had greater stage... -
I recently bought an RB1080. My speakers are 2.5 ohms, and I have to put a 200W non-inductive resistor in series with one side of the speaker cable to bring it up to 6.5 ohms, which the RB1080 handles just fine (It did NOT like 2 ohms and now I see in the specs the RB1080 works only down to 4 ohm, not... -
I'm going to write a little bit about these 2 Rotel amps from my experience with both in my system at the same time.
Setup:
SqueezeBox3 -> Rotel RC1070 preamp -> Rotel RB1070/Rotel RB1090 -> Martin Logan Summits -> Joey's ears
Build:
The 1070 is... -
I've just assembled a system, consisting of using a denon 3805, running preouts to an rb1090 and a rmb1095 ( unbalanced).
I am only getting weak sound out of the main right and left front but nothing out of the other five speakers which are connected to the Rmb1095.
I read... -
I currently have a Rotel Rb1090 driving two Aussie mainspeakers ( Vaf I-93 Signatures ) and a Rotel RMB1095 driving the centre and 4 surrounds ( Vaf I-91's ).
I am awaiting delivery of a singular horizontal version of the mainspeakers ( I-93) to replace my current centre channel. Now,...
Comment